Abstract
The internal temperature of a passive thermal shipper employing dry ice as the coolant often decreases to less than the equilibrium sublimation point (−78.5°C) during shipment. In this paper, we demonstrate that in many cases, this unexpected phenomenon is due to excessive sublimation cooling by the dry ice. We performed a series of experiments and determined the dry ice temperature with the change in dry ice sublimation rates under various external conditions. The results show that the sublimation temperature decreases to less than −80°C and decreases further when the dry ice sublimation rate is artificially increased. The lowest temperature observed in the experiments was −100.6°C, which occurred when the dry ice nuggets were subjected to a forced-air cooling condition, which is an extreme situation that is not expected to happen in actual shipping environments. Several types of shippers were also tested to investigate the impact of shipper material and shipper design. The lowest temperature observed in these shippers was −93.2°C when the shipper was placed on its side instead of upright. Based on the results from these controlled experiments, we conclude that the temperature inside a shipper cooled by dry ice will decrease because of excessive sublimation cooling effect but will not reach less than −100°C in normal shipping environments.
- © PDA, Inc. 2020
PDA members receive access to all articles published in the current year and previous volume year. Institutional subscribers received access to all content. Log in below to receive access to this article if you are either of these.
If you are neither or you are a PDA member trying to access an article outside of your membership license, then you must purchase access to this article (below). If you do not have a username or password for JPST, you will be required to create an account prior to purchasing.
Full issue PDFs are for PDA members only.
Note to pda.org users
The PDA and PDA bookstore websites (www.pda.org and www.pda.org/bookstore) are separate websites from the PDA JPST website. When you first join PDA, your initial UserID and Password are sent to HighWirePress to create your PDA JPST account. Subsequent UserrID and Password changes required at the PDA websites will not pass on to PDA JPST and vice versa. If you forget your PDA JPST UserID and/or Password, you can request help to retrieve UserID and reset Password below.