PT - JOURNAL ARTICLE AU - Dennis Jenke AU - Norman Liu AU - Yousheng Hua AU - Steven Swanson AU - Roy Bogseth TI - A Means of Establishing and Justifying Binary Ethanol/Water Mixtures as Simulating Solvents in Extractables Studies AID - 10.5731/pdajpst.2015.01046 DP - 2015 May 01 TA - PDA Journal of Pharmaceutical Science and Technology PG - 366--382 VI - 69 IP - 3 4099 - http://journal.pda.org/content/69/3/366.short 4100 - http://journal.pda.org/content/69/3/366.full SO - PDA J Pharm Sci Technol2015 May 01; 69 AB - Ethanol/water mixtures are frequently used as simulating solvents in extractables studies. However, the basis for determining and justifying the right ethanol proportion in a simulating solvent for a particular drug product or solution has not been previously established.A solvent strength model has been developed in this study, based on the correlation between the levels of a model compound, di-(2-ethylhexyl) phthalate (DEHP), extracted from a reference source material, plasticized poly-(vinyl chloride) (PVC) resin, and the proportion of ethanol in ethanol/water extractions solvents. This model was established by experimentally investigating DEHP leaching and takes the form: If the level of DEHP extracted from the standard source PVC resin by a drug product is measured, then the level can be input into the above equation and the proper ethanol content of the appropriate simulating solvent can be determined.The model has been applied to certain drug products and additives used in drug products, and the proper ethanol/simulating solvents for these products have been established. Additionally, the leaching behavior revealed in this study has been established to be consistent with previously published research and a mechanism for the observed behavior has been proposed.LAY ABSTRACT: Although ethanol/water mixtures are frequently used as simulating solvents in extractables studies, it is difficult to establish and justify what the right proportion of ethanol is for a particular drug product. A solvent strength model has been developed based on the leaching behavior of a model compound, di-(2-ethylhexyl) phthalate (DEHP), from a reference source material, plasticized poly-(vinyl chloride) (PVC). By measuring the level of DEHP leached into a drug product from the reference source material, one can use the model to calculate the correct ethanol proportion in the simulating solvent.Using this approach, ethanol/water proportions have been obtained for certain drug products. Additionally, the leaching profiles for DEHP obtained in this study were noted to be consistent with such profiles for other extractables from the PVC reference source material and with other investigations of ethanol/water as model stimulants.