PT - JOURNAL ARTICLE AU - Diane Paskiet AU - Crystal Kraft AU - Erica Tullo AU - Jeff Hunter AU - Diego Zurbriggen TI - Assessment of Extractable Elements from Elastomers AID - 10.5731/pdajpst.2017.008193 DP - 2019 Jan 01 TA - PDA Journal of Pharmaceutical Science and Technology PG - 83--91 VI - 73 IP - 1 4099 - http://journal.pda.org/content/73/1/83.short 4100 - http://journal.pda.org/content/73/1/83.full SO - PDA J Pharm Sci Technol2019 Jan 01; 73 AB - Compendia methods have historically been used to assess heavy metals in both drug products and packaging material extracts. However, these methods have been found to be inadequate for elemental specificity and accurate measurements. The International Council for Harmonization of Technical Requirements for Pharmaceuticals for Human Use (ICH) has published the Q3D, Guideline for Elemental Impurities, to provide a risk-based approach that specifies elements to be considered in a drug product risk assessment and permitted daily exposures (PDEs) depending on toxicological concern and route of administration. Consistent with these efforts, the United States Pharmacopeia (USP) withdrew the <231> Heavy Metals test procedure as of January 2018. The USP published new methods consistent with ICH Q3D risk-based approaches, <232> Elemental Impurities - Limits and <233> Elemental Impurities - Procedures. These new tests are intended for evaluation of drug products, leaving a gap in the assessment of extractable elements for packaging components. This gap prompted the need for a better understanding of the potential for elements of concern to extract from packaging materials and contribute to drug product elemental impurities. The present study investigated multiple extraction conditions coupled with modern analytical techniques to understand the capacity for elements to extract from elastomeric components. Most elements of interest, based on ICH or their potential for occurrence in elastomers, were ultimately recovered at levels below designated thresholds, allowing for correlation to PDE. These results highlight that although extractable elements from elastomeric components have the potential to contribute elemental impurities to a drug product, the actual contribution to cumulative levels would need to be calculated among all other potential sources as part of the process of elemental impurities assessment.LAY ABSTRACT: Compendia methods have historically been used to assess heavy metals in final drug products and extracts from packaging materials. However, these methods were found to provide inadequate data to address the evolving risk concerns of elemental impurities in drug products and their potential toxic effects. The International Council for Harmonization of Technical Requirements for Pharmaceuticals for Human Use member countries are working toward implementing a risk-based approach that specifies elements to be considered in a drug product safety assessment and permitted daily exposures. The United States Pharmacopeia is coordinating with this goal by withdrawing the traditional procedure and replacing it with the tests that can inform safety risk assessments. However, the new tests are intended for evaluation of only final drug products, leaving a gap in the assessment of extractable elements for packaging components. The present study addressed this gap by focusing on elastomeric components used in injectable packaging systems and exploring appropriate elastomeric extraction methods coupled with modern analytical techniques to better understand the full potential for elements to extract from elastomers and contribute to the elemental impurity profile of a drug product.