Abstract
The particulate levels found on supplier microcleaned rubber closures were compared to those of stoppers processed by a pharmaceutical manufacturer. The particle monitoring was performed using two official compendial methods: light blockage using a HIAC/ROYCO counter, and optical microscopy using a polarizing research microscope. The supplier-microcleaned stoppers were found to contain relatively few particles per stopper by both instrumental and microscopic counting. The cleaning process used by the pharmaceutical manufacturer was effective in reducing the particle load on their stoppers by factors of 2 to 20 fold as compared to the unwashed stoppers for the different size ranges measured. However, the supplier-microcleaned stoppers were found to be cleaner than those processed by the pharmaceutical manufacturer by a factor of 10 to 20 times for particle sizes >10 μm using the instrumental method. Differences in the counts by microscopic and light blockage methods were attributed to the sampling and agitation procedures. Both the supplier-microcleaned and manufacturer’s processed closures were found to meet the USP XXI limits for allowable particulate contamination in small volume parenterals.
- Received June 21, 1988.
- Accepted December 9, 1988.
- Copyright © Parenteral Drug Association. All rights reserved.
PDA members receive access to all articles published in the current year and previous volume year. Institutional subscribers received access to all content. Log in below to receive access to this article if you are either of these.
If you are neither or you are a PDA member trying to access an article outside of your membership license, then you must purchase access to this article (below). If you do not have a username or password for JPST, you will be required to create an account prior to purchasing.
Full issue PDFs are for PDA members only.
Note to pda.org users
The PDA and PDA bookstore websites (www.pda.org and www.pda.org/bookstore) are separate websites from the PDA JPST website. When you first join PDA, your initial UserID and Password are sent to HighWirePress to create your PDA JPST account. Subsequent UserrID and Password changes required at the PDA websites will not pass on to PDA JPST and vice versa. If you forget your PDA JPST UserID and/or Password, you can request help to retrieve UserID and reset Password below.