Abstract
The combination of chemical inertness and compliance required of a stopper for parenteral products has, to date, been inadequately met by any single material. Attempts to achieve these requirements by coating elastomeric stoppers have proven unsatisfactory. Lamination of chemically impervious PTFE to elastomeric base material has been shown to yield functionally desirable stoppers with limited cost effectiveness. An alternative technique in which polypropylene or polyethylene is bonded to a variety of elastomers has been proposed for a wide pH range parenteral stopper. Stability studies in which the functionality of the new stoppers is compared to the widely used bare butyl stopper and to PTFE faced stoppers are presented.
- Received October 25, 1983.
- Accepted May 14, 1984.
- Copyright © Parenteral Drug Association. All rights reserved.
PDA members receive access to all articles published in the current year and previous volume year. Institutional subscribers received access to all content. Log in below to receive access to this article if you are either of these.
If you are neither or you are a PDA member trying to access an article outside of your membership license, then you must purchase access to this article (below). If you do not have a username or password for JPST, you will be required to create an account prior to purchasing.
Full issue PDFs are for PDA members only.
Note to pda.org users
The PDA and PDA bookstore websites (www.pda.org and www.pda.org/bookstore) are separate websites from the PDA JPST website. When you first join PDA, your initial UserID and Password are sent to HighWirePress to create your PDA JPST account. Subsequent UserrID and Password changes required at the PDA websites will not pass on to PDA JPST and vice versa. If you forget your PDA JPST UserID and/or Password, you can request help to retrieve UserID and reset Password below.